Contacts
Address
Malaysia, Kuala Lumpur, No 21 -1, Jalan Cempaka SD 12/2 Bandar Sri Damansara 52200
Director
Manager
Phones of enterprise
management
+60
When placing an order please inform the manager that you've learned the information on Allbiz! Thank you that you buy on Allbiz!
Internet
Site:
About enterprise
Hanoja, Sdn. Bhd.
Hanoja is a Bumiputra company established in 1983, that specializes in technical seals for every application and is renowned for keeping stocks of every kind of standard design, material and size. A highly developed sales organization guarantees the fastest deliveries, anywhere in Malaysia.
Their collective experience together with Hanoja’s capabilities ensures that customers have the best possible technical support.
In stock
D-rings are often used as an alternative to o-rings in reciprocating dynamic applications because of their resistance to spiral failure.
They can be used for sealing on the ID or the OD.
Group: Gaskets for cylinder head
In stock
Square rings can be either molded or lathe-cut
Group: Gaskets for cylinder head
In stock
Oil seals are used to seal around a rotating shaft and keep an oil-based lubricant inside an axle, engine, etc.
Group: Gasket oil filters
In stock
Oil seals are used to seal around a rotating shaft and keep an oil-based lubricant inside an axle, engine, etc.
Group: Gasket oil filters
In stock
V-rings are installed on a rotating shaft and seal axially against the counter-face. V-rings are typically used to supplement other seals by serving as deflectors or by creating a labyrinth for contaminants.
Group: Paddings
In stock
X-rings can be used as an alternative to o-rings in dynamic applications because of their reduced friction and their resistance to spiral failure
Group: Paddings
In stock
O-ring cord can be supplied in bulk or spliced into O-rings of any ID.
Spliced O-rings can be a convenient and cost-effective alternative to molded O-rings when large ID's, small quantities or low compression set is required.
Group: Paddings
In stock
For face-type applications, the o-ring cross-section can be applied to non-circular openings or even when multiple openings require sealing. These sometimes are known as press-in-place gaskets
Group: Paddings
In stock
Square rings can be either molded or lathe-cut. The lathe-cut parts are often less expensive than comparably sized o-rings, especially for
larger IDs.
Group: Paddings
In stock
Is a mechanical gasket in the shape of a torus; it is a loop of elastomer with a disc-shaped cross-section, designed to be seated in a groove and compressed during assembly between two or more parts,creating a seal at the interface .
Group: Paddings
